![]() ![]() The Histogram - Table Generators Make it quick and easy to see exactly how far off every cell of you fuel table is by processing all the data in your logs. MegaLogViewer HD is the most feature filled version of MegaLogViewer with a log file loader designed to work with all delimited and many binary data logs. MegaLogViewer HD is designed to work with nearly ANY delimited and many binary logsįor most users, this is the MeagLogViewer you want. I'll log a few pulls after tuning is done and post the plots.The best of features and extends support to a vast array of data logs. When I get the car back on the dyno in April I will compare AFR readings in MSII with AFR as measured by the Dynpack. And the "egoVGauge" will correctly read 0-5V. The "afr1Gauge" will match the AEM EUGO gauge. ![]() If you want the LED bar on the bottom of the main display to read 0-5V, make these changes to you megasquirt-ii.ini file:ĮgoLEDs = 0.0, 1.0, 0.5 Voltage settings.ĮgoLEDs = 5.0, 0.0, 2.5 Lambda settings.ĮgoLEDs = 19.7, 9.7, 14.7 Afr settings. Tools -> Calibrate AFR Table - enter these settings (see attachment) Basic Setup -> EGO Control - "Select Single Wide Band", and "Simple" under Wide Band Controller settings for now. Same with the calibration of the AFR tables. Installation is easy, just connect power, the sensor, and run the whote wire to the O2 sensor input on the MSII.Įnable the EGO correction with the engine NOT RUNNING (there is a big warning about this in the Megatune manual). ![]() The nice thing about this unit is that it uses the inexpensive Bosch sensor, has a 0-5v analog output, and includes a nice gauge! It also has a serial output for data logging, but with all the logging capabilities in MSII, there is really no need to use it. AFR readings on the gauge and in MSII appear to correlate. ![]() I installed one of these in the race car last night: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |